|
FOLDING FOR THE MEDIUM SIZE DIAPER
Choose a flat surface large enough to spread the diaper, as shown below - a
table, a bed, even the floor if you find it comfortable. If the bottom part
hangs over the edge, as it does in the picture, that's fine, just as long as the
outer 'shell' (the stretchy triangular part) is on the flat surface.
(If you prefer, you can spread the flat part out to the right of the
centreline of the shell. It doesn't really make any difference.)

Taking the bottom two corners of the flat diaper, fold it up and
over itself, approximately along the dotted red line (above) and about one inch
below the bottom point of the shell (shown by the small red arrow).

Without letting go of the corners of the diaper, fold it back
down on itself along the second fold line (above), to approximately the position
shown below, if it's a girl.

Or, if you're folding for a boy, make the fold a bit bigger so
that, when you put the diaper on, the thickest part is further forward rather
than between the legs (below).
(We'll use the 'girl fold' for the rest of the medium fold
tutorial. But, don't worry, the remaining steps are identical for both boy and
girl options.)
Now, quickly smooth out any wrinkles by brushing your hands from the
centre to the outside edges of the flat as shown below. (This is to avoid
lumps which could be uncomfortable for the baby.)

Next we're going to fold the flat diaper in towards the centre
of the shell to form a thick pad. As shown below, fold the outside edge of the flat diaper
roughly 4 inches in towards the centre. Smooth out any wrinkles by
brushing your hands quickly in the direction shown by the straight arrows.
(You're going to smooth out the wrinkles with every fold, so
we won't repeat this again.)
Now fold the diaper in towards the centre a second time, this
time making the fold about 5 inches wide (below). (It
helps to note the position of each fold in relation to the shell.)

Make a third fold towards the centre, about the same width as
the second fold, i.e. approximately 5 inches (below).

The fourth and final fold is about half the width of folds two and
three and should bring the pad to the middle of the outer shell as
shown below.

And that, basically, is all there is to it! Two horizontal
folds, four vertical ones!
Addendum: The more adventurous among you might also consider trying
the 'five fold' diaper for a thicker but narrower pad. The only difference being
that, instead of making four vertical folds, you'll make five, the first
being roughly 2 inches wide, the next three each being about 4 inches wide; the
fifth fold will need to be about half the width of the fourth to bring the pad
to the middle.
Note: If you experience problems with runny bowel movements, the wider 'four
fold' pad is recommended.
YOUR ARISTOCRATS DIAPERS SHOULD BE WASHED BEFORE USING
Click here
for printable pdf version
A HINT ON STORAGE To store the
Aristocrats One Size Diaper you can just fold the two top points of the outer
shell across the middle pad, as shown below, and, assuming you've folded a bunch
ahead of time, stack them one on top of the other, ready for future diaper
changes.

RETURN TO TOP OF PAGE PUTTING THE DIAPER ON
RETURN TO TUTORIAL INTRODUCTION RETURN
TO ARISTOCRATS ONE SIZE DIAPER
ARISTOCRATS ONE SIZE DIAPER
US Patent No. 6,623,467
Canadian Patent Pending
© Aristocrats Baby Products 2008. All rights reserved.
|